Chevrolet S10 Pickup 2WD FFV Engine Oil Specs
Engine oil type, capacity & service interval for the Chevrolet S10 Pickup 2WD FFV (2001–2002). Select your year below for full specifications.
Choose S10 Pickup 2WD FFV year
Oil grade changes by year
Do not assume every Chevrolet S10 Pickup 2WD FFV year uses the same oil. Some years specify 5W-20 (years 2002) while others specify 0W-20 (years 2001). Select your exact year and engine configuration before buying oil.
Select Year – Chevrolet S10 Pickup 2WD FFV Engine Oil
2 years foundChevrolet S10 Pickup 2WD FFV Engine Oil Specs by Year
All 2 yearsChevrolet S10 Pickup 2WD FFV Engine Oil Guide
The Chevrolet S10 Pickup 2WD FFV was produced from 2001 to 2002. This model typically uses 5W-20 full synthetic engine oil — a specification common to most Chevrolet S10-series vehicles.
Selecting the correct oil viscosity for your Chevrolet S10 Pickup 2WD FFV is essential. Using a grade that is too thin reduces protection at operating temperature, while too thick an oil impairs cold-start flow and reduces fuel economy. Always match the exact grade shown for your specific model year.
The recommended oil change interval for the Chevrolet S10 Pickup 2WD FFV is every 5,000 miles or 6 months. Under severe driving conditions — track use, towing, or frequent cold starts — shorten this interval by 25–30%.
When servicing your Chevrolet S10 Pickup 2WD FFV, always replace the oil filter at every oil change. Using a quality filter — such as ACDelco or Mobil 1 filters matching GM specifications — helps maintain optimal filtration.
Oil change costs for the Chevrolet S10 Pickup 2WD FFV at a US dealership or local service center typically range from $60 to $110 for a standard synthetic blend or full synthetic service. DIY oil changes cost approximately $30–$65 in parts (oil + filter) and take about 30 minutes with the right tools.
Always consult your vehicle's owner's manual to confirm the exact specification for your specific trim and engine variant, as some Chevrolet S10 Pickup 2WD FFV configurations may have different requirements.
General Motors engines require oil certified with the dexos1 Gen 3 or dexos2 standard to protect direct-injection valvetrains.
Reset the Engine Oil Life system via the driver information center or by pumping the accelerator pedal three times with ignition ON.