Chevrolet HHR Panel FWD Engine Oil Specs
Engine oil type, capacity & service interval for the Chevrolet HHR Panel FWD (2007–2011). Select your year below for full specifications.
Choose HHR Panel FWD year
Oil grade changes by year
Do not assume every Chevrolet HHR Panel FWD year uses the same oil. Some years specify 5W-30 (years 2011, 2010, 2007) while others specify 5W-20 (years 2009, 2008). Select your exact year and engine configuration before buying oil.
Select Year – Chevrolet HHR Panel FWD Engine Oil
5 years foundChevrolet HHR Panel FWD Engine Oil Specs by Year
All 5 yearsChevrolet HHR Panel FWD Engine Oil Guide
The Chevrolet HHR Panel FWD was produced from 2007 to 2011. This model typically uses 5W-30 full synthetic engine oil — a specification common to most Chevrolet HHR-series vehicles.
Selecting the correct oil viscosity for your Chevrolet HHR Panel FWD is essential. Using a grade that is too thin reduces protection at operating temperature, while too thick an oil impairs cold-start flow and reduces fuel economy. Always match the exact grade shown for your specific model year.
The recommended oil change interval for the Chevrolet HHR Panel FWD is every 5,000 miles or 6 months. Under severe driving conditions — track use, towing, or frequent cold starts — shorten this interval by 25–30%.
When servicing your Chevrolet HHR Panel FWD, always replace the oil filter at every oil change. Using a quality filter — such as ACDelco or Mobil 1 filters matching GM specifications — helps maintain optimal filtration.
Oil change costs for the Chevrolet HHR Panel FWD at a US dealership or local service center typically range from $60 to $110 for a standard synthetic blend or full synthetic service. DIY oil changes cost approximately $30–$65 in parts (oil + filter) and take about 30 minutes with the right tools.
Always consult your vehicle's owner's manual to confirm the exact specification for your specific trim and engine variant, as some Chevrolet HHR Panel FWD configurations may have different requirements.
General Motors engines require oil certified with the dexos1 Gen 3 or dexos2 standard to protect direct-injection valvetrains.
Reset the Engine Oil Life system via the driver information center or by pumping the accelerator pedal three times with ignition ON.