Chevrolet Cruze Limited Eco Engine Oil Specs
Engine oil type, capacity & service interval for the Chevrolet Cruze Limited Eco (2016–2016). Select your year below for full specifications.
Choose Cruze Limited Eco year
Select Year – Chevrolet Cruze Limited Eco Engine Oil
1 year foundChevrolet Cruze Limited Eco Engine Oil Specs by Year
All 1 years| Year | Engine | Oil Grade | Capacity | Interval | |
|---|---|---|---|---|---|
| 2016 | 1.4L 4-Cylinder | 5W-30 | 3.7 qt | 7,500 mi | View → |
Chevrolet Cruze Limited Eco Engine Oil Guide
The Chevrolet Cruze Limited Eco was produced from 2016 to 2016. This model typically uses 5W-30 full synthetic engine oil — a specification common to most Chevrolet Cru-series vehicles.
Selecting the correct oil viscosity for your Chevrolet Cruze Limited Eco is essential. Using a grade that is too thin reduces protection at operating temperature, while too thick an oil impairs cold-start flow and reduces fuel economy. Always match the exact grade shown for your specific model year.
The recommended oil change interval for the Chevrolet Cruze Limited Eco is every 7,500 miles or 12 months. Under severe driving conditions — track use, towing, or frequent cold starts — shorten this interval by 25–30%.
When servicing your Chevrolet Cruze Limited Eco, always replace the oil filter at every oil change. Using a quality filter — such as ACDelco or Mobil 1 filters matching GM specifications — helps maintain optimal filtration.
Oil change costs for the Chevrolet Cruze Limited Eco at a US dealership or local service center typically range from $60 to $110 for a standard synthetic blend or full synthetic service. DIY oil changes cost approximately $30–$65 in parts (oil + filter) and take about 30 minutes with the right tools.
Always consult your vehicle's owner's manual to confirm the exact specification for your specific trim and engine variant, as some Chevrolet Cruze Limited Eco configurations may have different requirements.
General Motors engines require oil certified with the dexos1 Gen 3 or dexos2 standard to protect direct-injection valvetrains.
Reset the Engine Oil Life system via the driver information center or by pumping the accelerator pedal three times with ignition ON.